top of page



We use a number of different ways to restore life back into a DPF filter, but generally, it is the same format but in different set up. We do a diagnostic on the vehicle first to see why the car is not regenerating or how much % of Ash is left in the filter,  Most filters will get to 60% full and the regeneration safety settings kick in and de-activate the regeneration process, leaving you the owner with a dashboard of flashing lights and a vehicle that wont drive as expected but rather in what we call "Limp Mode"

We generally use a German Branded product's made by LAUNCH UK & MANNOL in a 2 stage cleaning process, this process is either done from the engine bay or under the vehicle itself, yes its a rather smoky experience and we do our upmost best to not leave any mess or marks on your driveway or road during the process. This means in the majority of instances there is no requirement to remove the DPF for cleaning.

The job normally takes anywhere from 1 hour to 3 hours and we always advise customers to get a new DPF pressure sensor prior to our arrival as "Sometimes" the DPF Pressure sensor can also be affected by the amount of miles, time and heat of the DPF's lifetime of use. We will offer to change the DPF pressure sensor as we do the job for you, If we can.

A DPF clean can increase your vehicle’s power output, increasing the speed, acceleration and responsiveness.

You can also expect a boosted fuel efficiency – the potential fuel savings could cover the cost of the cleaning over time!

In addition, a clean DPF will continue to serve its purpose which is to reduce harmful emissions, reduce engine noise and resolve MOT emissions failures. That’s right, a blocked filter could easily lead to a failed MOT.

Prices start at £199 depending on your location from us and what type of vehicle you have.

  • Facebook
  • Twitter
  • LinkedIn
  • Instagram


call us between 10am and 8pm 7 days.

07772 177677

bottom of page